CM3000

From Advanticsys Tech Resources
Jump to: navigation, search
CM3000
Type: Mote

The CM3000 mote is a IEEE 802.15.4 wireless sensor node based on the original open-source "TelosB" platform design developed and published by the University of California, Berkeley. The mote has the following general characteristics:

The CM3000 presents a compact design in which the traditional USB connector has been replaced with an ERNI® connector compatible with Interface modules. The Hirose® 51-pin connector also adds versatility to this product as it is attachable to all the sensor boards family, and the SMA design greatly increases coverage area through the use of a more powerful 5dBi external antenna.

Warning: To avoid damage to this device, make sure to remove batteries before plugging it to the host computer's USB port (via a USB1000 interface board).

Features

Item Specification Description
Processor
Processor Model TI MSP430F1611 Texas Instruments MSP430 family
Memory 48KB
10KB
1MB
Program flash
Data RAM
External Flash (ST® M25P80)
ADC 12bit resolution 8 channels
Interfaces UART, SPI, I2C Serial Interfaces
Radio
RF Chip TI CC2420 IEEE 802.15.4 2.4GHz Wireless Module
Frequency Band 2.4GHz ~ 2.485GHz IEEE 802.15.4 compliant
Sensitivity -95dBm typ Receive Sensitivity
Transfer Rate 250Kbps IEEE 802.15.4 compliant
RF Power -25dBm ~ 0dBm Software Configurable
Range ~300m(outdoor), 40~50m(indoor) With standard 5dBi antenna
Current Draw RX: 18.8mA TX: 17.4mA Sleep mode: 1uA Lower RF Power Modes reduce consumption
RF Power Supply 2.1V ~ 3.6V CC2420 Input Power
Antenna 5dBi Dipole Antenna SMA connector
Electromechanical Characteristics
Dimensions 72.80mm x 38.50mm x 13.30mm
Weight 17.7g Without batteries
Power 3V (2xAA Battery Holder Provided) MICREL® MIC5207 Power Regulator

51-pin Connector

The CM3000 includes an 51 pin Hirose®expansion connector, that allows the access to a number of pins in the microcontroller, and enables the use of Advanticsys® sensor board family.
51pinconnector.png

Resources